Echelon i.LON SmartServer 2.0 - Manual (Page 317)

i.LON SmartServer 2.0 Programmer’s Reference 19-17
This property specifies whether to start a test or
get the current status of the test. This property
may be set to one of the following values:
• ST_BEGIN. Starts the test.
• ST_STATUS. Returns the status of the test.
Required
A string specifying the e-mail address to where
the test e-mail will be sent. Optional
A string specifying the originator of the e-mail
message. Optional
A string specifying the subject line of the test
e-mail message. Optional
A string specifying the text of the test e-mail
message. Note that you may not include flags
such as those used by the Alarm Notifier
application. Optional
A string specifying a full path on the SmartServer
flash disk of a file to be attached to the test e-mail
message such as “/root/AlarmLog/sumlog1.csv”
if you were attaching an alarm log. Optional
UCPTcount This property specifies the number of times the
e-mail message will be sent. Optional
Note: If you are checking the status of a test ( is set to ST_STATUS), you only need to
provide the and properties.
The following examples demonstrate how to use the SystemService_Test function to test that the
default SMTP e-mail server can send out e-mail messages and check the status of the test:
Request (test the SMTP e-mail server)
SMTP_TEST
ST_BEGIN
[email protected]
sender
This is a test
Request (check the status of the SMTP e-mail server test)
SMTP_TEST
ST_STATUS