Echelon i.LON SmartServer 2.0 - Manual (Page 273)

i.LON SmartServer 2.0 Programmer’s Reference 16-6
16.2 M-Bus Devices
The following section describes how to use the List, Get, Set, and Delete functions on M-Bus devices.
16.2.1 Using the List Function on M-Bus Devices
You can use the List function to retrieve a list of M-Bus devices on the SmartServer. The List function
takes an element that has an xSelect statement with an MBS_Device_Cfg type as its input,
as shown in the example below.
Request
//Item[@xsi:type="MBS_Device_Cfg"]
Response
0
4.0
Net/M-Bus
Channel/M-Bus Device
App;xsi:type="MBS_Device_Cfg"
0
You could use the list of elements returned by this function as input for the Get function. The
Get function would then return the configuration of each device included in the list. The next section
describes the properties included in each of these elements.
16.2.2 Using the Get Function on M-Bus Devices
You can use the Get function to retrieve the configuration of an M-Bus device defined on the
SmartServer. The input parameters you supply to this function will include one or more
elements with an MBS_Device_Cfg type. Each element will include the of
each device whose configuration is to be returned by this function, as shown in the example below.
Request
xsi:type="MBS_Device_Cfg">
Net/M-Bus Channel/M-Bus Device
Response
0
xsi:type="MBS_Device_Cfg">
Net/M-Bus Channel/M-Bus Device
App
0
2008-04-02T14:47:25.970-07:00
MBS_Device_Cfg.htm
0
LonFormat="UCPTspeed">MS_2400
1
1
LonFormat="UCPTmbusMode">MD_MODE1