Echelon i.LON SmartServer 2.0 - Manual (Page 307)

i.LON SmartServer 2.0 Programmer’s Reference 19-7
Property Description R/W
The password used to access the SmartServer via FTP.
The default password is ilon. You can specify a
different password, which may be up to 20 characters
long and contain letters, numerals, and the underscore
character. r/w
A flag indicating whether the SmartServer can be
rebooted remotely via the Setup - Reboot Web page. r/w
> A flag indicating whether the security settings on the
Setup – Security Web page can be modified if secure
access mode is temporarily disabled. r/w
A flag indicating whether the security settings on the
Setup – Security Web page can be modified if secure
access mode is permanently disabled. r/w
The port the SmartServer uses for HTTP
communication. The default port is 80. r/w
The port the SmartServer uses for HTTPS
communication. The default port is 443. r/w
The port the SmartServer uses for HTTP
communication. The default port is 80. r/w
The port the SmartServer uses for HTTP
communication. The default port is 80. r/w
A flag indicating whether the SmartServer can be
accessed via HTTP. r/w
19.1.4 Static System Information
You can use the SystemService_Read_Info function to get general information about the SmartServer, including
hardware and firmware versions, flash memory capacity and limits, and FPM license status. To do this, you provide the
SystemService_Read_Info function with an element that includes one
property that is set to SI_STATIC.
Request
SI_STATIC
Response
2008-04-03T17:29:47.314-07:00
264000000
65398784
72102