Xerox 7042 - Manual (Page 126)

Maintenance Procedures
System errors
The following table lists some items to check if the machine is
not operating correctly:
Table 10-1:
System
Errors
Condition items to Check
The power does not
turn on. Check that the power cord is properly installed.
Check that the machine is receiving the correct
voltage. Connect another appliance to the AC wall
outlet to verify the voltage.
The document does
not feed.
Check that no more than 30 pages are loaded in
the ADF.
Check if the paper is fully inserted in the ADF.
Clean the scanner rollers and the ADF pad. Refer
to the Cleaning Procedures section in this chapter
for more information.
A blank page is
printed. Check if the document is loaded properly at the
sending machine.
Make a copy to test the machine operation.
The communication
finishes in an error. Check if the receiving machine has recording
paper loaded in its paper cassette.
Compare the error code with the information
codes in this chapter.
Retransmit the document at a later time.
The machine does
not answer an
incoming call.
Check whether the machine is in the automatic
answer mode. Refer to the
Receiving
chapter for
more information.
Check whether the machine is in the standby
mode or in the polling standby mode.
The machine does
not accept
documents into the
memory.
Check the available memory capacity. If the
memory Is almost full, print and delete any files
that are not necessary.
10-4