TeeJet Matrix Pro 840GS - Manual (Page 70)

64
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
IMPLEMENT
FULL SCREEN
GPS
INTR
ODUC
TION
GUID
ANCE
DR
OPLE
T MONIT
OR
Figure 8-18: Overlap
100% 50% 0%
OEM Spreader Implement Type
1. Select
Spreader
implement type on Implement screen.
2. Press NEXT PAGE arrow .
3. Select from:
►Setup Type – used to select
OEM
spreader type
►Antenna to Disks – used to enter the distance from the GPS
antenna to the delivery disks or dispersal mechanism. Range
is 0.0 to 164.04 feet / 0.0 to 50.0 meters.
►Start Distance – used to set the start distance when exiting an
applied area. Consult spreader manufacturer for value.
►Stop Distance – used to set the stop distance when entering
an applied area. Consult spreader manufacturer for value.
►Section Start Offsets – used to set the offset distance from
the leading edge of Section 1 to the leading edge of each
section. Section 1 is always 0.0 feet / meters. All other
sections can be a different distances. Sections are numbered
from left to right while facing in the machine's forward
direction. Consult spreader manufacturer for values.
►Section Stop Offsets – used to set the offset distance from
the leading edge of Section 1 to the trailing edge of each
section. Each section can be a different distances. Sections
are numbered from left to right while facing in the machine's
forward direction. Consult spreader manufacturer for value.
4. Press RETURN arrow to return to the Implement screen
or CONFIGURATION side tab to return to the main
Configuration screen.
Figure 8-19: Implement Setup Options in OEM Spreader Mode