TeeJet Matrix Pro 840GS - Manual (Page 24)

18
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
IMPLEMENT
FULL SCREEN
GPS
INTR
ODUC
TION
GUID
ANCE
DR
OPLE
T MONIT
OR
sensors
When a sensor is present on the system, options to setup and
configure the sensor will be available.
1. Press CONFIGURATION side tab
.
2. Press
Sensors
.
Figure 5-17: Sensors
The Pressure Sensor Interface Kit is recognized on the CAN bus as
an Input/Output Module (IOM)
Figure 5-18: Input/Output Module
Sensors Unavailable
If a Pressure Sensor Interface Kit is not installed, setup options will
not be available.
Figure 5-19: Pressure Sensor Interface Kit Not Detected
Pressure Sensor
When a Pressure Sensor Interface Kit is present, Pressure Sensor
options are used to enter the sensor manufacture's maximum
pressure rating and set high and low user determined pressure
alarms.
NOTE: If a Pressure Sensor Interface Kit is being used, the Droplet
Size Monitor will be available.
1. Press CONFIGURATION side tab .
2. Press
Sensors
.
3. Press
Pressure Sensor
.
4. Select from:
►Maximum Pressure Rating – used to establish the maximum
pressure rating of the pressure sensor as recommended by
the manufacturer
►Low Pressure Alarm– used to enter the user determined low
pressure point at which the alarm will sound
►High Pressure Alarm– used to enter the user determined high
pressure point at which the alarm will sound
5. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.