beautypg.com

Default spanning-tree configuration, User-changeable sta parameters – Interlogix GE-DSH-73 Series User Manual User Manual

Page 97

background image

Chapter 5: Web-Based Management

GE-DSH-73/DSH-82 and DSH-82-PoE User Manual

93

The following are the user-configurable STP parameters for the port or port group
level:

Variable

Description

Default Value

Port Priority

A relative priority for each port –lower
numbers give a higher priority and a
greater chance of a given port being
elected as the root port

128

Port Cost

A value used by STP to evaluate paths
– STP calculates path costs and selects
the path with the minimum cost as the
active path

200,000-100Mbps Fast Ethernet
ports

20,000-1000Mbps Gigabit
Ethernet ports

0 - Auto

Default Spanning-Tree Configuration

Feature

Default Value

Enable state

STP disabled for all ports

Port priority

128

Port cost

0

Bridge Priority

32,768

User-Changeable STA Parameters

The Switch’s factory default setting should cover the majority of installations.
However, it is advisable to keep the default settings as set at the factory; unless, it is
absolutely necessary. The user changeable parameters in the Switch are as follows:
Priority – A Priority for the switch can be set from 0 to 65535. 0 is equal to the highest
Priority.
Hello Time – The Hello Time can be from 1 to 10 seconds. This is the interval between
two transmissions of BPDU packets sent by the Root Bridge to tell all other Switches
that it is indeed the Root Bridge. If you set a Hello Time for your Switch, and it is not
the Root Bridge, the set Hello Time will be used if and when your Switch becomes the
Root Bridge.

This manual is related to the following products: