Interlogix GE-DSH-73 Series User Manual - Manual (Page 22)

Chapter 2: Installation
18 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
LED Indicators
The diagnostic LEDs that provide real-time information of system and optional status
are located on the front panel of the GE-DSH series. The following table provides the
description of the LED status and their meanings for the Managed Industrial Switch.
GE-DSH-82 LED Indicators
• System
LED Color Status Meaning
On The switch unit is power on.
PWR Green
Off No power.
On The industrial switch is the master of X-Ring group.
R.M. Green
Off
The industrial switch is not a ring master in X-Ring
group.
On Power 1 is active.
PWR1 Green
Off Power 1 is inactive.
On Power 2 is active.
PWR2 Green
Off Power 2 is inactive.
On Power or port failure.
FAULT Red
Off No failure.
• 10/100Base-TX Ports –
Port-1 to Port-8
LED Color Status Meaning
On A network device is detected.
Blinking
The port is transmitting or receiving packets from the
TX device.
Green
Off No device attached.
On The port is operating in full-duplex mode.
Blinking Collision of Packets occurs.
Port-1 ~ Port-8
Amber
Off
The port is in half-duplex mode or no device is
attached.