beautypg.com

Port commands set, Port commands set 140 – Interlogix GE-DSH-73 Series User Manual User Manual

Page 144

background image

Chapter 6: Command Sets

140

GE-DSH-73/DSH-82 and DSH-82-PoE User Manual

Port Commands Set

Commands

Level Description

Example

interface fastEthernet

[Portid]

G

Choose the port for
modification.

switch(config)#interface fastEthernet
2

duplex

[full | half]

I

Use the duplex
configuration command to
specify the duplex mode of
operation for Fast Ethernet.

switch(config)#interface fastEthernet
2

switch(config-if)#duplex full

speed

[10|100|1000|auto]

I

Use the speed configuration
command to specify the
speed mode of operation for
Fast Ethernet., the speed
can’t be set to 1000 if the
port isn’t a giga port..

switch(config)#interface fastEthernet
2

switch(config-if)#speed 100

no flowcontrol

I

Disable flow control of
interface

switch(config-if)#no flowcontrol

security enable

I

Enable security of interface switch(config)#interface fastEthernet

2

switch(config-if)#security enable

no security

I

Disable security of interface switch(config)#interface fastEthernet

2

switch(config-if)#no security

bandwidth type all

I

Set interface ingress limit
frame type to “accept all
frame”

switch(config)#interface fastEthernet
2

switch(config-if)#bandwidth type all

bandwidth type
broadcast-multicast-
flooded-unicast

I

Set interface ingress limit
frame type to “accept
broadcast, multicast, and
flooded unicast frame”

switch(config)#interface fastEthernet
2

switch(config-if)#bandwidth type
broadcast-multicast-flooded-unicast

bandwidth type
broadcast-multicast

I

Set interface ingress limit
frame type to “accept
broadcast and multicast
frame”

switch(config)#interface fastEthernet
2

switch(config-if)#bandwidth type
broadcast-multicast

bandwidth type
broadcast-only

I

Set interface ingress limit
frame type to “only accept
broadcast frame”

switch(config)#interface fastEthernet
2

switch(config-if)#bandwidth type
broadcast-only

bandwidth in

[Value]

I

Set interface input
bandwidth. Rate Range is
from 100 kbps to 102400
kbps or to 256000 kbps for

switch(config)#interface fastEthernet
2

switch(config-if)#bandwidth in 100

This manual is related to the following products: