Interlogix GE-DSH-73 Series User Manual - Manual (Page 149)

Chapter 6: Command Sets
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 145
Spanning Tree Commands Set
Commands Level Description Example
spanning-tree enable G Enable spanning tree switch(config)#spanning-tree enable
spanning-tree priority
[0~61440]
G Configure spanning tree
priority parameter switch(config)#spanning-tree priority
32768
spanning-tree max-age
[seconds]
G Use the spanning-tree max-
age global configuration
command to change the
interval between messages
the spanning tree receives
from the root switch. If a
switch does not receive a
bridge protocol data unit
(BPDU) message from the
root switch within this
interval, it recomputed the
Spanning Tree Protocol (STP)
topology. switch(config)#spanning-tree max-
age 15
spanning-tree hello-
time
[seconds]
G Use the spanning-tree hello-
time global configuration
command to specify the
interval between hello
bridge protocol data units
(BPDUs). switch(config)#spanning-tree hello-
time 3
spanning-tree forward-
time
[seconds]
G Use the spanning-tree
forward-time global
configuration command to
set the forwarding-time for
the specified spanning-tree
instances. The forwarding
time determines how long
each of the listening and
learning states last before
the port begins forwarding.
switch(config)#spanning-tree
forward-time 20