Interlogix GE-DSH-73 Series User Manual - Manual (Page 50)

Chapter 5: Web-Based Management
46 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
NOTE:
1. We recommend using Internet Explorer 6.0 or above to access GE-DSH-82 series
Managed Industrial Switch.
2. The changed IP address take effect immediately after clicking on the Save button.
You need to use the new IP address to access the Web interface.
3. For security reasons, please change and memorize the new password after this
first setup.
4. Only enter commands in lowercase letters when using the web interface.
System
Use the System menu items to display and configure basic administrative details of
the Managed Industrial Switch. Under System the following topics are provided to
configure and view the system information: This section has the following items:
System Information Provides basic system description, including contact information
IP Configuration Sets the IP address for management access
DHCP Server Configure the Switch as a DHCP server for assigning dynamic IP
addresses to devices on a network.
TFTP Upgrade the firmware via TFTP server
Save/view the switch configuration to remote host
Upload the switch configuration from remote host
Fault Relay Alarm Provides relay output for port breakdown, power fail
SNTP Configuration Simple Network Time Protocol. Configures SNTP client settings, including
broadcast mode or a specified list of servers
IP Security Supports 10 IP addresses that have permission to access the switch
management and to prevent unauthorized intruder.
User Authentication Allows configuring the system user name and password required to
access the web pages or log in from CLI.
Factory Default Reset the configuration of the Managed Industrial Switch
System Reboot Restarts the switch