Interlogix GE-DSH-73 Series User Manual - Manual (Page 161)

Chapter 6: Command Sets
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 157
SystemLog, SMTP and Event Commands Set
Commands Level Description Example
systemlog ip
[IP address]
G Set System log server IP
address. switch(config)# systemlog ip
192.168.1.100
systemlog mode
[client|server|both]
G Specified the log mode switch(config)# systemlog mode both
show systemlog E Displays system log. Switch>show systemlog
show systemlog P Show system log client &
server information switch#show systemlog
no systemlog G Disable systemlog functon switch(config)#no systemlog
smtp enable G Enable SMTP function switch(config)#smtp enable
smtp serverip
[IP address]
G Configure SMTP server IP switch(config)#smtp serverip
192.168.1.5
smtp authentication G Enable SMTP authentication switch(config)#smtp authentication
smtp account
[account]
G Configure authentication
account
switch(config)#smtp account John
smtp password
[password]
G Configure authentication
password
switch(config)#smtp password 1234
smtp rcptemail
[Index] [Email address]
G Configure Rcpt e-mail
Address switch(config)#smtp rcptemail 1
[email protected]
show smtp P Show the information of
SMTP switch#show smtp
no smtp G Disable SMTP function switch(config)#no smtp
event device-cold-start
[Systemlog|SMTP|Both]
G Set cold start event type switch(config)#event device-cold-
start both
event authentication-
failure
[Systemlog|SMTP|Both]
G Set Authentication failure
event type switch(config)#event authentication-
failure both
event ring-topology-
change
[Systemlog|SMTP|Both]
G Set X-ring topology changed
event type switch(config)#event ring-topology-
change both
event systemlog
[Link-UP|Link-
Down|Both]
I Set port event for system log switch(config)#interface fastethernet
3
switch(config-if)#event systemlog
both