EVCO EPH4DXP1CT Installer manual - Manual (Page 50)

Evco S.p.A. c-pro 3 CLIMA sistema | Installer manual ver.1.1 | Code 144CP3CSE114
page 50 of 74
7.2 Main page
The main page is displayed during the ON state:
By pressing the DOWN key it is possible to select whether to access the State, pages, the Main Menu or the System
Network, described below.
By pressing ESC key, the controller will go back to the main display of the MCCT thermal power plant controller.
7.3 State pages
By accessing the STATUS menu from the “Main Page” access the state pages relative to the DHW circuit (boiler), the
two solar panels circuits and the auxiliary circuit (aux1) managed by the MCPS regulator.
7.3.1 Functioning state of DHW circuit (boiler)
The DHW circuit state page (boiler) will contain the following information:
The DHW (boiler) circuit state pages show, as well as the state of the line described in the previous illustration, the
regulation temperature of the DHW tank (i.e. the lower of the two), the DHW tank work set-point, the upper and lower
temperature of the DHW tank and the days missing to the next planned running of the antilegionella cycle.
Pressing ENTER on the “>” access the next state page, corresponding with the SOLAR PANELS CIRCUIT 1.
By pressing ENTER on the “<” access the last state page, i.e. the AUXILIARY 1 CIRCUIT state page.
When the 60 seconds time-out has passed or by pressing ESC, the controller will go back to the display of the main ON
page.
7.3.2 Functioning state of solar panels circuit 1 and 2
The functioning state page of the solar panels circuits 1 and 2 will contain the following information:
The state page of the solar panels circuit 1-2 shows, as well as the state of the line described in the previous
illustration, the temperature of the water in the solar panels circuit and the maximum temperature accepted before
the high temperature alarm is signalled
Pressing ENTER on the “>” access the next state page, corresponding with the SOLAR PANELS CIRCUIT 2.
By pressing ENTER on the “<” access the previous state page, i.e. the DHW CIRCUIT state page.
When the 60 seconds time-out has passed or by pressing ESC, the controller will go back to the display of the main ON
page.
7.3.3 Functioning state of auxiliary circuit
The auxiliary circuit state page will contain the following information:
The state page of the auxiliary circuit shows, as well as the state of the line described in the previous illustration, the
temperature of the water of the auxiliary circuit and its work set-point set.
Pressing ENTER on the “>” access the next initial state page, corresponding with the DHW CIRCUIT.
By pressing ENTER on the “<” access the previous state page, i.e. the SOLAR PANELS 2 state page.
When the 60 seconds time-out has passed or by pressing ESC, the controller will go back to the display of the main ON
page.