EVCO EPH4DXP1CT Installer manual - Manual (Page 30)

Evco S.p.A. c-pro 3 CLIMA sistema | Installer manual ver.1.1 | Code 144CP3CSE114
page 30 of 74
5.4 Clock menu
From this menu you can set/change the value of the date and time that the module c-pro 3 MCCT extends to the
whole c-pro 3 CLIMA sistema.
To set/modify the date and/or real time, press ENTER on “Real time clock” and set the desired value.
If the ESC key is pressed from a setting page or 60 timeout seconds are allowed to pass, you go back to the main
page of the application. This level is not protected by a password.
5.5 User menu
The user menu level 1, that is used to enter the password of the user level to be able to view/edit the parameters in
this branch.
From the menu you can view ON/OFF button from the system and change the operating mode (Summer and Winter).
5.6 Maintenance menu
The menu is level 2, that is used to enter the password level of maintenance to be able to view/edit the parameters in
this branch.
In this menu you can view the hours of operation of utilities and it is also possible to change the operating mode
(auto-manual), select the zones to enable, set the anti-grip operation and finally the calibration of the probes.
5.7 Installer menu
The Installer menu is level 3, that is used to enter the password installer level to be able to view/edit the parameters
in this branch.
From this menu you can view and set the configuration of the system managed by the MCCT.
Below is a list of the menus can be set:
- Lines Menu: we define the main characteristics relating to discharge lines present and enabled on the system such as
the type of controlled delivery lines present, the presence of the mixing valve, how to manage the circulation pumps
and the definition of their type of digital input protection.
- Control Menu: you can set the configuration of the system (boiler, chiller, heat pump and antifreeze system).
- Pumps Menu: we define the timing of the pumps of all the lines
- Valves Menu: you define the offset of the heating curve, valid for all lines in the system. From this menu you access
the operating parameters of the mixing valves.
- Alarms Menu: you can enable and set the various alarms of the thermal plant.
- Others Menu: finally, it is possible to set the general parameters.
5.8 Manufactor menu
The menu manufactor is level 4, that is used to insert the manufactor level password in order to view/edit the
parameters in this branch.
From this menu you can select the elements of the installation and configure Input/Output.
Below is a list of the menus can be set:
- Settings Menu: entering the settings you define the main features present in the controlled such as the presence and
type of heating elements/cooling elements (boiler, chiller, heat pump), the number of lines of output and the number
of zone controllers MCZN present, the presence of the module for the management MCPS tank ACS and/or plant solar
panels.
- Menu I/O: enter this menu, you can set the logic of the digital inputs/outputs