beautypg.com

Gs r n, Gs r, Gs r – Citizen Systems BD2-2220 User Manual

Page 93

background image

- 93 -

GS r n

CT-S280

CT-S300

CT-S2000

CT-S4000

BD2-2220

CT-S310

support model

PMU2XXX

[Function]

Sending status

[Code]

<

1D>H<72>H

[Range]

CT-S280

/

BD2-2220

/

PMU2XXX

n=1、49

CT-S300

/

CT-S2000

/

CT-S4000

/

CT-S310

1≦n≦2、49≦n≦50

[Outline]

[The specification which is common to the model]

Sends the specified status to the host.

n Function

1,49

Sends the Paper Sensor status.

2,50

Sends the Drawer Kick-out Connector status.

[Caution]

[The specification which is common to the model]

• When the serial interface is used:

For DTR/DSR control:

The printer sends the status after verifying that the host is ready to receive. If the host is not
ready to receive, the printer waits for the host to become ready to receive.

For XON/XOFF control:

The printer sends the status without checking whether the host is ready to receive or busy.

• Because this command is executed when data is mapped in the receive buffer, there may be a

delay between receiving the command and sending the status depending on the condition of the
receive buffer.

• If ASB (Automatic Status Back) is enabled by GS a, the host must discriminate between the status

due to this command and the status due to ASB.

• Whenever the Paper-end Sensor detects a “paper out” state, the printer goes offline, and the

command is not executed. Therefore, the printer never sends a status “No paper in Paper-end
detector (0CH)”.

[The specification which depend on the model]

CT-S280

/

BD2-2220

/

PMU2XXX

• At the setting of MSW3-7 OFF, paper sensor status is fixed to 00h.

This manual is related to the following products: