Citizen Systems BD2-2220 - Manual (Page 88)

- 88 -
ESC u n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Sending the peripheral device status
[Code] < 1B>H<75>H
[Outline] [The specification which is common to the model]
Send the current drawer kick connector pin#3 status.
• n has the type shown in the table below:
n Connector Pin
Drawer kick connector pin#3 0
[Caution] • Status to be sent uses 1 byte that has the value listed in the table below.
• DTR/DSR control sends 1 byte only after checking that host is ready to receive (DSR signal: space
status). For XON/XOFF control, 1 byte is sent without checking DSR signal status.
• For DTR/DSR, if host is not ready to receive (DSR signal: mark status), it waits for ready condition
to receive.
• Paper-end status causes BUSY status, thus this command may be in the receive-not-ready status.
• This command is valid only when MSW3-7 is set to ON.
Value
Bit Function
0 1
Pin #3 level 0 ‘L’ ‘H’
Undefined 1 ―― ――
Undefined 2 ―― ――
―― Undefined 3 ――
Unused 4 0: Fixed ――
Undefined 5 ―― ――
Undefined 6 ―― ――
Undefined 7 ―― ――
[Sample Program]
OPEN "COM1:N81NN" AS #1 → OPEN statement depends on types of BASIC.
PRINT #1,CHR$(&H1B);"ｕ";CHR$(0)
A$ = INPUT$(1, #1)
CLOSE #1