Citizen Systems BD2-2220 - Manual (Page 127)

- 127 -
GS g 2 m nL nH
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Sending maintenance counter
[Code] < 1D>H<67>H<32>H
[Range] m=0
20≦(nL+nH×256)≦198
nL=20、21、50、70、148、149、178、198
nH=0
[Outline] [The specification which is common to the model]
Send the maintenance counter value specified.
nL, nH are used to set the maintenance counter number to (nL+nH×256).
Counter Number
Counter ［Unit］ Counter Type
Hex. Decimal
14 20 Paper-feed line［line］ Resettable
15 21 Head powering count ［times］ Resettable
32 50 Auto-cutter drive count ［times］ Resettable
46 70 Product operation time［hours］ Resettable
94 148 Paper-feed line［line］ Accumulated
95 149 Head powering count ［times］ Accumulated
B2 178 Auto-cutter drive count ［times］ Accumulated
C6 198 Product operation time［hours］ Accumulated
• Configuration of data to be sent is shown below for the maintenance counter.
Hex. Decimal Data Count
Header 5FH 95 1 byte
30H～39H 48～57 Data 1 - 10 bytes
NUL 00H 0 1 byte
[Caution] • During sending block data (maintenance counter value), real-time status and ASB status shall not
be sent. Thus, during sending the data, printer status can not be notified.
• Counter value sent by this command is only a guideline value. Due to an error occurrence and
power off timing, figure data may have an error.
• To update the flash memory, write the flash memory if any change occurs in the
maintenance counter when the period where the printer is not in operation (printing,
paper feeding, drawer, or cutting) lasts about 10 seconds, 2 minutes, and 1 hour.
• If change occurs in each counter, data on RAM is updated correspondingly.