Citizen Systems BD2-2220 - Manual (Page 228)

- 228 -
GS I n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Caution] • Under DTR/DSR control, the printer sends the printer ID after verifying that the host is ready to
[Outline] [The specification which depend on the model]
[Range] CT-S280 / BD2-2220
[Code] < 1D>H<49>H
[Function] Sending the printer ID
• Sending the Black mark length is valid only when Black mark paper is selected.
CT-S300 / CT-S2000 / CT-S4000 / CT-S310 / PMU2XXX
• If ASB (Automatic Status Back) is enabled by GS a, the host must discriminate between the printer
ID due to this command and the status due to ASB.
• Because this command is executed when data is mapped in the receive buffer, there may be a
delay between command receiving and printer ID sending depending on the condition of the
receive buffer.
• Under XON/XOFF control, the printer sends the printer ID without checking whether or not the
host is ready to receive.
• If the host is not ready to receive, the printer waits for the host to become ready to receive.
Sends the specified printer ID.
1≦n≦4、49≦n≦52、65≦n≦67、n＝69、112
CT-S300 / CT-S2000 / CT-S4000 / CT-S310 / PMU2XXX
1≦n≦3、49≦n≦51、65≦n≦67、n＝69、112
receive.