Citizen Systems BD2-2220 - Manual (Page 79)

- 79 -
GS v 0 m xL xH yL yH d1 ... dk
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Printing of raster bit image
[Code] < 1D>H<76>H<30>H〔〕k
[Range] 0≦m≦3、48≦m≦51、0≦xL≦255、0≦xH≦255、
0≦yL≦255、0≦yH≦8、0≦d≦255、
k=(xL+xHЧ256)Ч(yL+yH×256) ,however,k≠0
[Outline] [The specification which is common to the model]
Prints raster bit images in mode “m”.
Dot Density in Dot Density in
Mode Name m
Vertical Direction Horizontal Direction
0,48 NORMAL MODE 203dpi 203dpi
1,49 DOUBLE WIDTH MODE 203dpi 101dpi
2,50 DOUBLE HEIGHT MODE 101dpi 203dpi
3,51 QUADRUPLE SIZE MODE 101dpi 101dpi
• xL, xH specify the number of data in horizontal direction of the bit image to (xL+xH×256) bytes.
• yL, yH specify the number of data in vertical direction of the bit image to (yL+yH×256) bytes.
[Caution] [The specification which is common to the model]
• Any of the print modes (character size, emphasis, double strike, inverting, underlining,
back-to-white reversing, etc.) does not affect the raster bit image.
• If the print area specified by GS L and GS W is narrower than a minimum width, the print area for
that line only is extended to the minimum width. The minimum width is one dot in NORMAL
MODE (m = 0, 48) and DOUBLE HEIGHT MODE (m = 2, 50), and 2 dots in DOUBLE WIDTH
MODE (m = 1, 49) and QUADRUPLE SIZE MODE(m = 3, 51).
• Any part of data that is out of the print area is only read and discarded in units of dot.
• The print start position can arbitrarily be specified with HT (horizontal tab), ESC $ (specifying
absolute position), ESC ＼ (specifying relative positions), and GS L (setting left margins). Note that
if the print start position is not a multiple of 8, the printing speed may decrease.
• The setting of ESC a (aligning characters) are also valid for the raster bit image.
• If this command is executed during macro definition, the macro definition is suspended, and the
processing of the command starts. The macro is left undefined.
• “d” denotes defined data. Dots to be printed are specified as “1”, and those not to be printed as
“0”.
[The specification which depend on the model]
CT-S280 / CT-S300 / BD2-2220 / CT-S310 / PMU2XXX
• Valid only when no print data is present in the print buffer at the selection of STANDARD
MODE.
CT-S2000 / CT-S4000
• Valid only when no print data is present in the print buffer (at the top of a line).