Citizen Systems BD2-2220 - Manual (Page 227)

- 227 -
GS ( A pL pH n m
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Execution of test printing
[Code] < 1D>H<28>H<41>H
[Range] (pL+(pH×256))=2(pL=2、pH=0)
0≦n≦2、48≦n≦50
1≦m≦3、49≦m≦51
[Outline] [The specification which depend on the model]
Specified test printing will be executed.
• pL, pH will specify the number of subsequent parameters by (pL+(pHx256))bytes.
• “n” will specify the paper for test printing in the following table.
n Category of Paper
0,48 Basic paper (Paper rolls)
1,49
Paper rolls
2,50
• “m” will specify the category of test printing in the following table.
m Category of Test Printing
1,49 Hexadecimal dump
2,50 Printer’s status printing
3,51 Rolling pattern printing
[Caution] • This command is only valid when processed at the head of a line during the STANDARD MODE.
• The command will be ignored in PAGE MODE.
• During macro definition, if this command is processed, the macro definition is suspended, and the
command starts being processed.
• Printer will reset its hard disk after finishing test printing. Therefore, the printer makes download
characters, bit map images and macros undefined, clears the reception buffer/print buffer, and
returns the various settings to defaults. At this time, the DIP switches are read again.
• Paper cutting is performed at the end of test printing.
*Functions with cutter-mounted model and when cutter is set to be enabled.
• Printer will be BUSY when the processing of the command starts.