Citizen Systems BD2-2220 - Manual (Page 269)

- 269 -
4.1.4 CT-S4000
No. Setting OFF ON
MSW1-1 Power ON Info ● Valid Not send
MSW1-2 Buffer Size ● 4K bytes 45 bytes
MSW1-3 Busy Condition ● Full/Err Full
MSW1-4 Receive Error ● Print “?” No Print
MSW1-5 CR mode ● Ignored LF
MSW1-6 Reserved ● Fixed ―
MSW1-7 DSR Signal ● Invalid Valid
MSW1-8 Init Signal ● Invalid Valid
MSW2-1 Reserved ― ● Fixed
MSW2-2 Auto Cutter Invalid ● Valid
MSW2-3 Spool Print ● Invalid Valid
MSW2-4 Full Col Print ● LineFeed WaitData
MSW2-5 Resume aft PE ● Next Top
MSW2-6 Reserved ● Fixed ―
MSW2-7 Reserved ● Fixed ―
MSW2-8 PNE Sensor ● Valid Invalid
MSW3-1 Resum Cttr Err ● Valid Invalid
MSW3-2 Reserved ● Fixed ―
MSW3-3 Parallel 31 Pin ● Valid Invalid
MSW3-4 Reserved ● Fixed ―
MSW3-5 Reserved ● Fixed ―
MSW3-6 Reserved ● Fixed ―
MSW3-7 CBM1000 Mode ● Invalid Valid
MSW3-8 Resum Open Err ● Close Command
MSW4-1 P.Length Set Auto Measure Command
MSW4-2 Power on TOF ● Invalid Valid
MSW4-3 FEED&CUT at TOF Invalid ● Valid
MSW4-4 Paper Select(*1) Thermal Roll BM.P/Lbl.P
MSW4-5(*3) Position Detect(*2) Black Mark Label
MSW4-6 Reserved ● Fixed ―
MSW4-7 Reserved ● Fixed ―
MSW4-8 Partial only Invalid ● Valid
MSW5-1 Buzzer Valid ● Invalid
MSW5-2 Line Pitch ● 1/360 1/406
MSW5-3 USB Mode Virtual COM ● Printer Class
MSW5-4 Reserved ● Fixed ―
MSW5-5 Power OFF Info ● Invalid Valid
MSW5-6 Reserved ● Fixed ―
MSW5-7 Reserved ● Fixed ―
MSW5-8 Reserved ● Fixed ―
●: Factory setting
*1）Default for paper selection depends on the model selected.
*2）Invalid when thermal rolled paper is selected by MSW4-4.
Black mark option product is fixed at black mark detection.
*3）Valid only with black mark or label-support model.
Black mark is optional.