beautypg.com

Citizen Systems BD2-2220 User Manual

Page 164

background image

CT-S310


• Setting memory switch 3 (a = 3)

• Setting memory with 1 (a = 1)

n b (Set Value)

Function

n b (Set Value)

Function

48 (Default)

Reports the power on.

48 (Default)

After clearing cutter error, can be restored by Feed SW.

1

1

49

Does not report power on.

49

After clearing cutter error, cannot be restored by Feed SW.

48 (Default)

Sets input buffer capacity to 4K bytes.

2 48(Default)

Reserved

2

49

Sets input buffer capacity to 45 bytes.

48 (Default)

Resets with parallel pin 31.

3

48 (Default)

Sets input buffer full and offline to be Busy.

49

Does not reset with parallel pin 31.

3

49

Sets to be busy with input buffer full.

48(Default)

Uses thermal paper

4

48 (Default)

At the occurrence of receiving error, replaces the data with
“?”.

49

Uses Black mark paper

4

48(Default)

Used with 48/32 print columns

5

49

At the occurrence of receiving error, ignores the data.

49

Used with 42/30 print columns

48 (Default)

Disables CR (0DH).

6 48

(Default)

Undefined

5

49

Enables CR (0DH).

6 48

(Default)

Reserved

48 (Default)

Does not reset at serial I/F pin 6.

7

49

Resets at serial I/F pin 6.

48 (Default)

Does not reset at serial I/F pin 25.

8

49

Resets sat serial I/F pin 25.

*

With MSW1-2, parallel I/F (4K fixed) and USB I/F (16K fixed) are disabled.

• Setting memory switch 2 (a = 2)

n b (Set Value)

Function

1 49

(Default)

Reserved

48

Disables auto cutter.

2

49 (Default)

Enables auto cutter.

48 (Default)

Enables stored printing.

3

49

Disables stored printing.

48

Immediately after digit reaches full, line-feed is taken.

4

49 (Default)

Immediately after digit reaches full, data wait is taken.

48 (Default)

After cover close and PE recovery, prints as it is.

5

49

After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.

48(Default)

Sets paper width to 80 mm

6

49

Sets paper width to 58 mm

7 48(Default)

Reserve

48(Default) Enables

PNE.

8

49 Disables

PNE.

48 (Default)

Sets CBM1000-noncompatible mode.

7

49 Sets

CBM11000-compatible

mode.

Sets cover open error during printing to be auto recovery
error.

48 (Default)

8

Sets cover open error during printing to be recoverable
error.

49

- 164 -

This manual is related to the following products: