beautypg.com

Gs v m ・・・ (1), Gs v m n ・・・ (2), Gs v m ・・・ (1) gs v m n ・・・ (2) – Citizen Systems BD2-2220 User Manual

Page 102: Gs v

background image

- 102 -

GS V m ・・・ (1)
GS V m n
・・・ (2)

CT-S280

CT-S300

CT-S2000

CT-S4000

BD2-2220

CT-S310

support model

PMU2XXX

[Function]

Cutting the paper

[Code]

(1)<1D>H<56>H

(2)<1D>H<56>H

[Range]

(1)0≦m≦1、48≦m≦49

(2)m=65、66

0≦n≦255

[Outline]

[The specification which is common to the model]

Performs the specified paper cutting.

m Function

0,48 Full

cut

1,49

Partial cut (Leaving a bridge area uncut)
Paper feed by “cut position + {n×basic calculation pitch}” and full cut

65

Paper feed by “cut position + {n×basic calculation pitch}” and partial cut

66

[Caution]

[The specification which is common to the model]

• In STANDARD MODE, this command only works when it is entered at the beginning of a line.
• Control to make the length of cut paper less than 10 mm is not executed.

For (1):

• Executes cutting of paper.

For (2):

• If n = 0, the paper is fed to the cut position, and then cut. If n ≠0, the paper is fed by “n x

basic calculation pitch” inches past the cut position, and then cut.

• The basic calculation pitch is set by GS P. The paper feed amount is calculated with the vertical

basic calculation pitch (y). A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is omitted.

[The specification which depend on the model]

CT-S300

/

CT-S2000

/

CT-S4000

/

CT-S310

/

PMU2XXX

• With label- or BM-supported model, this command does not function at the setting of BM

paper/label paper setting.



This manual is related to the following products: