Esc l – Citizen Systems BD2-2220 User Manual

Page 224

- 224 -

ESC L

CT-S280

CT-S300

CT-S2000

CT-S4000

BD2-2220

CT-S310

support model

PMU2XXX

[Function]

Selecting PAGE MODE

[Code]

1B>H<4C>H

[Outline]

[The specification which depend on the model]

Switches from STANDARD MODE to PAGE MODE.

[Caution]

• This command is only effective if it entered at the beginning of a line.

• This command is not effective if it is entered when in PAGE MODE.
• STANDARD MODE is restored when printing specified by FF is finished or when ESC S is issued.
• The character mapping start position will be the point specified by ESC T in the print area specified

by ESC W.

• The commands listed below, which have separate settings for PAGE MODE and STANDARD

MODE, are changed to the settings for PAGE MODE use.

(1) Spacing setting:

ESC SP, FS S

(2) Line feed width setting: ESC 2, ESC 3

• The following commands are valid only in PAGE MODE.

(1) ESC V Specifying/canceling 90°-right-turned characters.
(2) ESC a Aligning the characters.
(3) ESC { Specifying/canceling the inverted characters.
(4) GS L

Setting the left margin.

(5) G3S W Setting the print area width.

• The following commands are disabled in PAGE MODE.

(1) GS ( A Executes test printing.
(2) FS p

Prints NV memory bit image.

(3) FS q

Defines NV memory bit image.

(4) GS v 0 Prints raster bit image.

• ESC @ restores STANDARD MODE.

、

CAN

、