Dle dc4 fn d1...d7 （specification of fn = 8, Dle dc4 fn d1...d7 （ specification of fn = 8, Dle dc4 – Citizen Systems BD2-2220 User Manual
Page 221
- 221 -
DLE DC4 fn d1...d7 （Specification of fn = 8）
CT-S280
CT-S300
CT-S2000
CT-S4000
BD2-2220
CT-S310
support model
PMU2XXX
[Function]
Buffer clear
[Code]
<
10>H<14>H
[Range]
fn=8、d1=1、d2=3、d3=20、d4=1、d5=6、d6=2、d7=8
[Outline]
[The specification which depend on the model]
• Erases all data in receiving buffer or print buffer.
• Sends the following 3-byte data group.
Hex.
Decimal
No. of Data
Header 37H
55
1
byte
Identifier 25H
37
1
byte
NULL 00H
0
1
byte
• Enters the state of selecting STANDARD MODE.
[Caution]
• If another data string of <10>H<04>H
with this command. Therefore, the user should be reminded of this fact.
[Example 1]
Suppose a command “ESC * m nL nH [d1 ... dk]”, where d1 = <10>H, d2 = <04>H, d3 = <01>H.
• The DLE EOT n command cannot be interleaved into the code string of another command
consisting of 2 bytes or more.
[Example 2]
If the printer sends DLE EOT 3 after the host has sent up to ESC 3 in its attempt to send ESC 3 n,
the printer handles the ESC 3 as ESC 3 <10>H. Thus, the user should be cautious.
• This command is ignored during transmission of block data.