Esc 3 n, Esc 3 – Citizen Systems BD2-2220 User Manual
Page 75
- 75 -
ESC 3 n
CT-S280
CT-S300
CT-S2000
CT-S4000
BD2-2220
CT-S310
support model
PMU2XXX
[Function]
Setting line feed rate of minimum pitch
[Code]
<
1B>H<33>H
[Range]
0≦n≦255
[Outline]
[The specification which is common to the model]
Sets the line feed width per line to [n×basic calculation pitch] inches.
[Caution]
• The line feed width can be set separately for the STANDARD and PAGE MODES.
• The basic calculation pitch is set by GS P. Once defined, the line feed width is not changed if the
basic calculation pitch is changed by GS P.
• Fractions resulting from calculation are corrected with the minimum pitch of the mechanism, and
the remainder is omitted.
• In STANDARD MODE, this command uses the vertical (paper feed direction) basic calculation pitch
(y).
• In PAGE MODE, this command acts differently depending on the start point:
(1) If the start point specified by ESC T is top left or bottom right, the command uses the vertical
(paper feed direction) basic calculation pitch (y).
(2) If the start point specified by ESC T is top right or bottom left, the command uses the
horizontal (perpendicular to the paper feed direction) basic calculation pitch (x).
• The maximum settable line feed width is 1016 mm (40 inches). A setting greater than this
maximum is trimmed to the maximum.
[Default]
CT-S300
/
CT-S280
/
BD2-2220
/
CT-S310
/
PMU2XXX
Approx. 4.23mm
CT-S2000
/
CT-S4000
(1) When memory switch 5-2 is OFF:
Approx. 4.23mm
(2) When memory switch 5-2 is ON:
Approx. 3.75 mm
[See Also]