Citizen Systems BD2-2220 - Manual (Page 156)

CT-S280
• Setting memory switch 3 (a = 3) • Setting memory with 1 (a = 1)
n b (Set Value) Function n b (Set Value) Function
48 (Default) Reports the power on. 1 48 (Default) Reserve 1
49 Does not report power on.
2 48 (Default) Reserve
48 (Default) Sets input buffer capacity to 4K bytes.
48 (Default) Resets with parallel pin 31.
2
3
49 Sets input buffer capacity to 45 bytes.
49 Does not reset with parallel pin 31.
48 (Default) Sets input buffer full and offline to be Busy.
4 48 (Default) Reserve 3
49 Sets to be busy with input buffer full.
5 48 (Default) Reserve
At the occurrence of receiving error, replaces the data with
“?”.
48 (Default)
6 48 (Default) Reserve 4
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
8 48 (Default) Reserve
• Setting memory switch 2 (a = 2)
n b (Set Value) Function
1 49(Default) Reserve
2 48(Default) Reserve
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After cover close and PE recovery, prints as it is.
5
49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6 49 (Default) Reserve
7 48 (Default) Reserve
48 (Default) Enables PNE.
8
49 Disables PNE.
48 Sets CBM270-noncompatible mode. 7
49 (Default) Sets CBM270-compatible mode.
Sets cover open error during printing to be auto recovery
error.
48 (Default)
8
Sets cover open error during printing to be recoverable
error.
49
- 156 -