KEYENCE GL-RHG Series - Manual (Page 28)

2-4 GL-RHG-M-NO2-E
Fu
nct
ion
s and
Feat
ures
2
2-2
Functions
The wiring system and the type of cable used with the GL-RHG determine the functions that can be used.
 : Available without the configuration software
 : Available with the configuration software
Wiring system
Optical
synchronization
One-line Wire synchronization
Page
Cable
combination
Cable for the transmitter 5-core
Series
connection
7-core 11-core
Cable for the receiver 5-core 11-core 5-core 11-core 7-core 11-core 7-core 11-core
Available
function
OSSD output         2-5
AUX (auxiliary) output     2-23
Error output     2-24
Muting function   2-7
Muting lamp output   2-24
Override function   2-20
EDM function     2-6
Wait input     2-22
Reset input (for error)     A-4
Channel configuration
(Light interference prevention
function)
        3-11
Center indicator configuration         5-4
Monitoring function         6-14
Requirement Function Page
Output a signal when an error occurs. Error output function 2-24
Output a signal for monitoring by the PLC. AUX output function 2-23
Suspend the GL-RHG's safety functions temporarily while the workpiece is passing
through the detection area.
Muting function 2-7
Suspend the GL-RHG's safety functions temporarily in order to activate the machine
while the workpiece remains in the detection area.
Override function 2-20
Separate the power supplies for the transmitter and receiver which are located far
away from each other.
Optical synchronization 2-2
Make sure whether the beam axes are optically aligned. Monitoring function 6-14