KEYENCE GL-RHG Series - Manual (Page 21)

1-1 Products
1-7 GL-RHG-M-NO1-E
Bef
o
re Use
1
Software and Interface Unit
Required options when monitoring GL-RHG on a PC
"Chapter 6 Monitoring method Using the Configuration Software" (page 6-1)
Point Configuration data created by the configuration software cannot be uploaded to GL-RHG.
The configuration software can only monitor GL-RHG.
 Configuration software
The configuration software can be downloaded from the KEYENCE website.
http://www.keyence.com
If you can not access the internet, call the nearest KEYENCE office.
 Interface unit (GL-R1UB)
Point
USB cable to connect the interface unit and the personal computer is not supplied. Please
acquire [A: miniB] type USB cable on yourself.
(You can also use the following option USB cables)
 USB cable 2 m (OP-51580)
 USB cable 5 m (OP-86941)
Dedicated Safety Reley for the GL-R Series (Model: GL-T11R)
Point For connection between GL-RHG and GL-T11R, the cable shown on "Cables" (page 1-2)
cannot be used.
Relay terminal to convert control output to contact relay. Connection
between GL-RHG and GL-T11R is made using the dedicated connector
cable. Each I/O line of GL-RHG is assigned to each terminal block of GL-T11R.
For details, refer to
"GL-T11R Instruction Manual".