KEYENCE DL-EP1 - Manual (Page 20)

- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (IL) -
2-2 Installation and Connection to Sensor Amplifiers
2-4
2
Con
nect
io
n a
nd
Conf
ig
urat
io
n
„ Connecting the DL-EP1 to sensor amplifiers
The EtherNet/IP Compatible Network Unit DL-EP1 must be connected to sensor
amplifiers before it can function.
The connecting procedure varies with the mounting type of the sensor amplifiers to
be connected.
For the instructions on connecting additional sensor amplifiers, refer to the
instruction manual of each sensor amplifier.
z Connecting to sensor amplifiers of the DIN rail mount type
1
Remove the expansion protective cover from the sensor amplifier to be
connected.
2
Mount the EtherNet/IP Compatible Network Unit DL-EP1, on the DIN rail
and connect it to the sensor amplifier.
Insert the EtherNet I/P Compatible Network Unit DL-EP1 to the sensor amplifier
connector so as not to leave space between them.
Make sure that the sensor amplifiers are turned off before
connecting the EtherNet/IP Compatible Network Unit DL-EP1.
Connecting the DL-EP1 to the sensor amplifiers when they are
turned on may damage the DL-EP1.
Make sure that the sensor amplifier connector (for DIN rail mount
type) is not askew on the side face of the EtherNet/IP Compatible
Network Unit DL-EP1 according to the figure shown below.
Connecting the DL-EP1 to the sensor amplifier with the connector
being askew may damage the DL-EP1.
NOTICE
Point
Sensor amplifier
Expansion protective cover
Sensor amplifier
EtherNet/IP Compatible Network Unit
DL-EP1
Connector
NOTICE
Sensor amplifier connector
EtherNet/IP Compatible Network Unit DL-EP1