Configuration procedures, Configuration procedures -2 – KEYENCE DL-EP1 User Manual
Page 18
2-2
2
Con
nect
io
n a
nd
Conf
ig
urat
io
n
- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (IL) -
2-1
Procedures from Installation before Using the DL-EP1 to Configuration
This section describes the procedures before you use the DL-EP1.
The above configurations enable communication.
For the outline of scanner side configuration for communication with an Allen-Bradley
scanner, refer to
"Procedures for Communicating with an Allen-Bradley
Configuration Procedures
1. Installation and Connection to Sensor Amplifiers
Connecting the DL-EP1 to sensor amplifiers (Page 2-4)
Assigning ID Numbers (Page 2-6)
2. Wiring
3. Configuring Communication with the DL-EP1
4. Configuring Communication with the Scanner
Connecting a communication cable (Page 2-8)
Setting the IP address (Page 2-10)
Setting the IP address (Page 2-13)
Registering the device profile of the DL-EP1 (Page 2-13)
Configuring the Scanner Side
(Refer to each scanner manual.)