Using iscsi, Changing the iscsi target authentication, Entering mutual authentication permissions – Dell POWERVAULT MD3600I User Manual
Page 47: 4 using iscsi
4
Using iSCSI
NOTE: The following sections are relevant only to MD
xx
0i storage arrays that use the iSCSI protocol.
Changing The iSCSI Target Authentication
To change the iSCSI target authentication:
1.
In the AMW, select the Setup tab.
2.
Select Manage iSCSI Settings.
The Manage iSCSI Settings window is displayed and by default, the Target Authentication tab is selected.
3.
To change the authentication settings, select:
– None — If you do not require initiator authentication. If you select None, any initiator can access the
target.
– CHAP — To enable an initiator that tries to authenticate the target using Challenge Handshake
Authentication Protocol (CHAP). Define the CHAP secret only if you want to use mutual CHAP
authentication. If you select CHAP, but no CHAP target secret is defined, an error message is displayed.
See
.
4.
To enter the CHAP secret, click CHAP secret.
The Enter Target CHAP Secret dialog is displayed.
5.
Enter the Target CHAP secret.
The Target CHAP secret must be at least 12 characters and up to 57 characters.
6.
Enter the exact target CHAP secret in Confirm target CHAP secret.
NOTE: If you do not want to create a CHAP secret, you can generate a random CHAP secret automatically. To
generate a random CHAP secret, click Generate Random CHAP Secret.
7.
Click OK.
NOTE: You can select the None and CHAP at the same time, for example, when one initiator may not have
CHAP and the other initiator has only CHAP selected.
Entering Mutual Authentication Permissions
Mutual authentication or two-way authentication is a way for a client or a user to verify themselves to a host server, and
for the host server to validate itself to the user. This validation is accomplished in such a way that both parties are sure
of the other’s identity.
To add mutual authentication permissions:
1.
In the AMW, select the Setup tab.
2.
Select Manage iSCSI Settings.
The Manage iSCSI Settings window is displayed.
3.
Select the Remote Initiator Configuration tab.
4.
Select an initiator in the Select an Initiator area.
47