Metrohm 788 IC Filtration Sample Processor - Manual (Page 96)

4 Operation
788 IC Filtration Sample Processor
88
4.4 Manual operation
4.4.1 Turning the sample rack / Positioning the samples
Using the <Í> and <Î> keys the sample rack can be
turned one position to the left (in the counterclockwise direction)
or right (clockwise).
8
MOVE
manual operation
MOVE 1 : sample
sample,spec.1}8,
1}999
Position vessel /
Turn rack
With the MOVE command, a particular sample tube or other
vessel can be placed under the needle. With the numerical rack position as well as the predefined current sam-ple (SAMPLE command) or the special beakers 1-8 can be cho-sen. For security reasons turning the sample rack is only possible when the lift is in or above the shift position.
4.4.2 Moving the lift The keys <Ï> and <Ð> allow upward and downward move-ment of the lift. The lowest possible lift position is defined by the configuration parameter 'max. lift way'. HOME END The key runs the lift to the rest position (0 mm), i.e. to the upper limit.
runs the lift to the predefined work position (see sec-tion 4.3.2). 9LIFT manual operation
LIFT: 1 : rest mm work,rinse,shift, special,rest, 0}125 mm Position the lift With the LIFT command, the lift can be run to a given position. In addition to selecting an exact position in mm (0 - 125 mm), the key can select a predefined position (work
numerical rack position as well as the predefined current sam-
ple (SAMPLE command) or the special beakers 1-8 can be cho-
sen.
For security reasons turning the sample rack is only possible
when the lift is in or above the shift position.
4.4.2 Moving the lift
The keys <Ï> and <Ð> allow upward and downward move-
ment of the lift. The lowest possible lift position is defined by the
configuration parameter
'max. lift way'
.
HOME END
The key runs the lift to the rest position (0 mm), i.e. to
the upper limit.
runs the lift to the predefined work position (see sec-
tion 4.3.2).
9
LIFT
manual operation
LIFT: 1 : rest mm
work,rinse,shift,
special,rest,
0}125 mm
Position the lift
With the LIFT command, the lift can be run to a given position.
In addition to selecting an exact position in mm (0 - 125 mm),
the
position, rinse position, shift position, special position, rest
position = 0 mm).