Metrohm 788 IC Filtration Sample Processor - Manual (Page 141)

6.1 Error messages
788 IC Filtration Sample Processor
133
6 Appendix
6.1 Error messages
When an error occurs the execution of the active command is inter-
rupted and an error message is displayed (display blinks). This must be
acknowledged with the key.
If an error occurs during processing of a sample series, the 788 IC Fil-
tration Sample Processor will then be switched into the "HOLD" state.
After the cause of the error has been rectified, the sample series can be
continued with the next command in the active sequence by pressing
the key. If the error cannot be eliminated, the method run-
ning can also be halted with .
The list of possible error messages and their causes:
Error message Cause
* battery low The battery for the permanent storage
of user methods must be replaced.
* wrong rack The rack positioned is not the one
that was assigned to the method un-
der 'parameters' .
* rack data missing No sample rack is in position or no
rack data can be found for the sam-
ple rack that is in place.
* raise lift first Turning of a rack could not be carried
out because the lift was below the
defined shift position.
* user memory full The memory for the user-defined
methods is full. Before saving a new
method, methods that are not used
or used only rarely must be deleted.