Metrohm 788 IC Filtration Sample Processor - Manual (Page 70)

4 Operation
788 IC Filtration Sample Processor
62
Key Normal state Edit mode
x "<" serves also for shifting the
chain of characters to chose from,
i.e. the text cursor is shifted one
place to the left for each instance
(see section 4.1.6).
*
>
ENDSEQ Initialization
x The 788 IC Filtration Sample
Processor is initialized with the
key followed by
.
x A method in the working memory
remains unchanged. The rack and
the lift are run to the initial position.
Text entry
x In a menu or sequence line in which
entry of text is required, (e.g.
method name), text edit mode is
activated with ">". Existing text
remains in this event and the text
cursor is set at the end of the exist-
ing character string.
x ">" serves also for shifting the
chain of characters to chose from,
i.e. the text cursor is shifted one
place to the right for each instance
(see section 4.1.6).
Set end mark
x For test purposes an
command can be placed at any line
desired in a sequence. This has the
effect that the sequence is only
executed up to this end mark.
START
Start a method
x The key starts a
method. Starting is only possible
when the IC Sample Processor is in
the normal state, i.e. when 'ready'
is shown in the display.
x When starting a sample series, the
sample counter is set to 0.
x When is pressed after
an interruption (), the
sequence is continued with the next
command line.
Trace function
x During editing of a sequence, the
command defined in the command
line can be directly executed with
the key.
x A sequence can therefore be tested
from start to finish (or in parts) in
single steps ("tracing").