Metrohm 788 IC Filtration Sample Processor - Manual (Page 85)

4.3 Methods
788 IC Filtration Sample Processor
77
parameters
>start sequence Start sequence of a sample series
The processing sequence entered here is executed once at
the start of a sample series. This can be useful for switching
on external devices, for example.
In this submenu up to 99 command lines can be entered as a
processing sequence (see section 4.3.3).
parameters
>sample sequence Processing sequence for each sample
This processing sequence is executed during the process-
ing of every sample of a series.
In this submenu up to 99 command lines can be entered as a
processing sequence (see section 4.3.3).
parameters
>final sequence Final sequence of a sample series
This processing sequence is executed once at the end of a
sample series. This could be the useful for switching off ex-
ternal devices, for example.
In this submenu up to 99 command lines can be entered as a
processing sequence (see section 4.3.3).
parameters
>changer settings Settings for 788 IC Filtration Sample Processor
>changer settings
rack number 2
0}16
Rack that is assigned to the method
0 = no particular rack
This setting can force the use of a certain rack with the
method chosen. If this is not desired, the rack number
'0' must be chosen.
>changer settings
lift rate 1 12 mm/s
3}12 mm/s
Stroke speed of lift
>changer settings
shift rate 20
3}20
Rack shift rate
Turning speed of the rack in angular degrees/second