9 tubing connections – Metrohm 788 IC Filtration Sample Processor User Manual
Page 27
2.3 Attaching the accessories
788 IC Filtration Sample Processor
19
2.3.9 Tubing
connections
The tubing connections on the 788 IC Filtration Sample Processor and
the connection to the injection valve of the 733 IC Separation Center
must be made as follows:
Pump tubings are consumable material with a lifetime which depends
on the contact pressure (see chapter 6.3.3). This is why the tubing
cartridges should be raised completely by loosening snap-action lever
16
16
16
16
on the right-hand side if the pump is to remain switched off for a
considerable length of time (the set contact pressure remains
unchanged).
The 6.1826.0X0 pump tubing is made of PVC and must not be used
for rinsing with solutions which contain acetone. In such cases, rinse
with different pump tubing or a different pump.
8/21
8/21
8/21
8/21
19
19
19
19
10/11
10/11
10/11
10/11 43
43
43
43
14
14
14
14
18
18
18
18
43
43
43
43
19
19
19
19
24/20
24/20
24/20
24/20
16
16
16
16
6666
6666
Abb. 10: Installing the pump tubing
Line 1: Conveying the sample
to the ultra-filtration cell
Line 2: Conveying the filtrate
to the injection loop
8888 PTFE capillary (6.1803.070)
21
21
21
21 PTFE capillary (6.1803.050)
6666 PEEK compression fitting
(6.2744.010)
6666 PEEK compression fitting (6.2744.010)
19
19
19
19
PEEK coupling (6.2744.030)
19
19
19
19
PEEK coupling (6.2744.030)
10
10
10
10 Pump tubing (6.1826.070)
11
11
11
11 Pump tubing 6.1826.030
43
43
43
43 Stopper (yellow/yellow)
43
43
43
43 Stopper (orange/yellow)
14
14
14
14
Tubing cartridge (6.2755.000)
14
14
14
14
Tubing cartridge (6.2755.000)
18
18
18
18
Contact pressure lever
18
18
18
18
Contact pressure lever
16
16
16
16 Snap-action lever
16
16
16
16 Snap-action lever
24
24
24
24
PTFE capillary (6.1803.060)
20
20
20
20
PEEK capillary (6.1831.060)