Metrohm 788 IC Filtration Sample Processor - Manual (Page 20)

2 Installation
788 IC Filtration Sample Processor
12
2.3 Attaching the accessories
For attaching the accessories at the 788 IC Filtration Sample
Processor, proceed in the order described below.
2.3.1 Connecting the swing head
Plug in the branch plug of the connection cable 29 29 29 29 permanently
attached to the swing head into the remote connection socket at the
788 IC Filtration Sample Processor and screw it onto this connection
using a screw-driver (see Fig. 1).
2.3.2 Connecting the keyboard
1
2
Connecting the keyboard
Connect the 6.2142.010 keyboard
to the keyboard connection 39 39 39 39
"Keyboard". For disconnection,
press the plug together slightly on
both sides.
Switch on instrument
Switch on the 788 IC Filtration
Sample Processor with mains
switch 34 34 34 34. The keyboard display
lights up. The instrument is
initialized and the lift is raised
completely.
Fig. 4: Keyboard connection
2.3.3 Installing the plug cover
To prevent any contamination of the mains and remote connection by
spilled solvents or chemicals, the 6.2752.010 plug cover must always
be installed when operating the 788 IC Filtration Sample Processor!
Install the plug cover 31 31 31 31 in the corresponding guide groove above
mains connection plug 33 33 33 33 and remote connection 30 30 30 30 (see Fig. 1 and
Fig. 2).