Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 44)

Chapter 4 Installing FactoryTalk Historian
44 Rockwell Automation Publication HSE-IN024A-EN-E–December 2012
purposes rather than real-life production environments. It is
recommended to install the FactoryTalk Historian Live Data
Interface on a different computer than the FactoryTalk Historian
server, typically on a data server computer.
NOTE
For more information on buffering, see "Enable Buffering (page 100)".
To install the FactoryTalk Historian Live Data Interface on the
data server computer:
1. Run the FactoryTalk Historian SE installation DVD.
2. On the welcome page of the installation wizard, click
Install
FactoryTalk Historian SE > Install FactoryTalk Historian Live
Data Interface.
The installation wizard appears.
If there are any software prerequisites missing from the
computer, they are listed in red at the bottom of the
installation wizard Welcome page. Click Cancel and Finish
to exit the wizard, install the prerequisites, and start the
installation wizard again.
3. On the Welcome... page, click Next.
4. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
5. Click Next.
6. On the Review Component Installation page, review the list
of the components that are already installed and those that will
be installed during the installation process.
Click Next.
7. On the Destination Drive page, select the drive on which you
want to install the product.
If the space available on the drive is not sufficient for the
installation, a warning message will appear below the