Enter message configuration -9, Enter message configuration – Rockwell Automation 1756-SYNCH ControlLogix SynchLink Module User Manual User Manual
Page 71

Publication 1756-UM521C-EN-P - July 2004
Troubleshooting the SynchLink Module 6-9
Enter Message Configuration
After creating a new tag, you must enter message configuration.
Enter message configuration on the following screens:
• Configuration Pop-Up Screen
• Communication Pop-Up Screen
A description of the purpose and set-up of each screen follows.
Click here to see the message
configuration pop-up screens
IMPORTANT
In RSLogix 5000, version 10 and greater, the message
configuration screens changed significantly to make it
easier for you to configure you messages.
For example, in version 9 and earlier, depending on the
Message Type, you are required to configure some
combination of the following:
• Service Code
• Object Type
• Object ID
• Object Attribute
• Source
• Number of Elements
• Destination
In version 10 and greater, however, you are only required
to choose a Service Type. RSLogix 5000 fills in most of the
fields listed above. You are only required to configure the
Instance field; Instance represents the module channel on
which the service is performed, if appropriate
The following sections show how to configure messages
with RSLogix 5000, versions 9 and earlier and RSLogix
5000, versions 10 and greater.