Rockwell Automation 1756-SYNCH ControlLogix SynchLink Module User Manual - Manual (Page 58)

Publication 1756-UM521C-EN-P - July 2004
5-6 Configuring the SynchLink Module
5. When you click on Next, you see the series of wizard screens that enable
you to configure the module.
Although each screen maintains importance during online monitoring,
some of the screens that appear during this initial module configuration
process are blank. They are not shown here.
Click here to move to the next page
Click here to move to the next page
Use the pull-down menu, to choose
which axis data tags to transmit
over each axis.
Adjust the Requested Packet Interval
Inhibit the connection to the module
If you want a Major Fault on the Controller to
occur if there is connection failure with the
I/O module while in Run Mode, click here
This Fault box is empty when you are offline.
If a fault occurs while the module is online,
the type of fault will be displayed here. The
fault is a connection fault explaining why a
connection did not open.