Rockwell Automation 1791DS-IBxxxx Guard I/O DeviceNet Safety Modules - Manual (Page 81)

Rockwell Automation Publication 1791DS-UM001J-EN-P - May 2013 81
Chapter
6
Configure Modules in RSNetWorx for DeviceNet
Software
This chapter provides information about how to configure Guard I/O modules
by using RSNetWorx for DeviceNet software and a SmartGuard controller. Refer
to the corresponding software help files for network-configurator operating
procedures.
This chapter covers how to configure a SmartGuard controller and Guard I/O
module by using Universal Serial Bus (USB) connectivity.
Before You Begin Be sure you have these required items:
• RSNetWorx for DeviceNet software, version 8.0 or later
• RSLinx software, version 2.51 or later
• SmartGuard USB driver
The SmartGuard USB driver should already be in your RSLinx software. If
it is not, load the driver onto your computer, noting the folder location as
you need to browse to it later.
• Personal computer with a Microsoft Windows 2000, Microsoft Windows
2000 Terminal Server, or Microsoft Windows XP operating system
Topic Page
Before You Begin 81
Add Modules to the I/O Configuration 82
Configure the I/O Module 86
Save and Download the Module Configuration 92
Set Up the 1791DS I/O Module Definition 93
Troubleshooting 109