Rockwell Automation 1791DS-IBxxxx Guard I/O DeviceNet Safety Modules - Manual (Page 158)

158 Rockwell Automation Publication 1791DS-UM001J-EN-P - May 2013
Appendix A Get Point Status from Modules by Using Explicit Messaging
.
Explicit Messages
Table 30 - Error Codes
Response
Code (hex) Error Name Cause
08FF Service not supported The service code is incorrect.
09FF Invalid attribute value The specified attribute value is not supported. The data written was outside valid range.
16FF Object does not exist The specified instance ID is not supported.
15FF Too much data The data is larger than the specified size.
13FF Not enough data The data is smaller than the specified size.
0CFF Object state conflict The specified command cannot be executed due to an internal error.
20FF Invalid parameter The specified operation command data is not supported.
0EFF Attribute is not setable An attribute ID supported only for reading has been executed for a write service code.
10FF Device state conflict The specified command cannot be executed due to an internal error.
14FF Attribute not supported The specified attribute is not supported.
19FF Store operation failure The data cannot be stored in memory.
2AFF Group 2 only server general failure The specified command or attribute is not supported or the attribute was not set.
Table 31 - Reading General Status
Explicit Message Read/
Write Function Command (hex) Response
Service
Code Class ID Instance ID Attribute
ID
Data Size
General Status Read Read Read the specified Slave’s
status flags (8 bits). 0E 95 01 65 - 1 byte
Bit 0: Input power error
Bit 1: Output power error
Bit 2…7: Reserved
Table 32 - Setting and Monitoring a Safety Input
Explicit
Message Read/
Write Function Command (hex) Response (hex)
Service
Code Class ID Instance ID Attribute ID Data Size
Safety Input
Cause of Error
Information
Read Read Reads the cause for the normal
flag (1…12) specified by the
Instance ID turning OFF. 0E 3D 01…0C 6E - 0: No error
01: Configuration invalid
02: External test signal error
03:Internal input error
04: Discrepancy error
05: Error in the other dual channel input