Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual - Manual (Page 93)

94 Rockwell Automation Publication 193-UM011A-EN-P - September 2010
Chapter 8 Trip History and Snapshot
Warning History Codes
Code Type Description
0 No Fault No Fault Conditions Detected
1 Ground Fault Power conductor or motor winding is shorting to ground
2 L1 Undercurrent Line 1 current is lower than the programmed level
3 L2 Undercurrent Line 2 current is lower than the programmed level
4 L3 Undercurrent Line 3 current is lower than the programmed level
5 L1 Overcurrent Line 1 current exceeds the programmed level
6 L2 Overcurrent Line 2 current exceeds the programmed level
7 L3 Overcurrent Line 3 current exceeds the programmed level
8 L1 Loss Current in line 1 is not present
9 L2 Loss Current in line 2 is not present
10 L3 Loss Current in line 3 is not present
11 Comm Fault DeviceNet communications fault detected
12 Comm Idle DeviceNet idle condition detected
13 Config Fault Parameter configuration fault. Check configuration parameters for the
proper values.
14 PM - # Starts Number of starts has exceeded the programmed level
15 PM- Oper. Hours Number of operating hours has exceeded the programmed level
TripHistory Mask
This parameter allows the user to configure
which current based protection features are
written to the five record Trip History as
outlined in the table below:
1 = Recorded
0 = Not Recorded
Parameter Number 142
Access Rule Get/Set
Data Type UINT
Object Mapping 0Fhex-8E-01
Group TripWarn History
Units —
Minimum Value 0000000000000000
Maximum Value 1111111111111111
Default Value 1101111101111111
Bit Function:
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
X Ground Fault
X L1 Undercurrent
X L2 Undercurrent
X L3 Undercurrent
X L1 Overcurrent
X L2 Overcurrent
X L3 Overcurrent
X L1 Loss
X L2 Loss
X L3 Loss
X Comm Fault
X Comm Idle
X Hardware Fault
X Test Trip
X Remote Trip
X NonVol Mem Fault