Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual - Manual (Page 88)

Rockwell Automation Publication 193-UM011A-EN-P - September 2010 89
Diagnostic Parameters Chapter 7
Firmware
This parameter allows the installer to read
the firmware revision number (FRN) of the E3
Overload Relay. Parameter Number 22
Access Rule Get
Data Type UINT
Object Mapping B4hex-01-0C
Group Monitor
Units —
Minimum Value 0
Maximum Value 65535
Default Value —
Dev Config
This parameter allows the installer to read
which features are enabled in the E3
Overload Relay as outlined in the table
below:
1 = On or Present
0 = Off or Not Present
Parameter Number 23
Access Rule Get
Data Type UINT
Object Mapping B4hex-01-14
Group Monitor
Units —
Minimum Value —
Maximum Value —
Default Value —
Bit Function:
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
X 4 in/2 out
X PTC Hardware
X GF Hardware
X External GF
X Heat Trace
Warn Log 0
This parameter records the latest warning.
Parameter Number 90
Access Rule Get
Data Type WORD
Object Mapping 29hex-1-109
Group Monitor
Units —
Minimum Value See Warning Status Table
Maximum Value See Warning Status Table
Default Value 0
Warn Log 1
This parameter records the warning previous
to Warn Log 0.
Parameter Number 91
Access Rule Get
Data Type WORD
Object Mapping 29hex-1-110
Group Monitor
Units —
Minimum Value See Warning Status Table
Maximum Value See Warning Status Table
Default Value 0