Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual - Manual (Page 70)

Rockwell Automation Publication 193-UM011A-EN-P - September 2010 71
Programmable Parameters Chapter 5
➊ For Catalog Number 193-EC4ZZ
➊ For Catalog Number 193-EC4ZZ
L3 OC Trip Level
This parameter sets the over current trip
level for line 3.
Parameter Number 124
Access Rule Get/Set
Data Type UINT
Object Mapping 2C
hex
-1-175
2C hex -1-189 ➊
Group Advanced Setup
Units 0.01 Amps
1 Amps
➊
Minimum Value 0.20
Maximum Value 5000
Default Value
L3 OC Trip Delay
This parameter allows the installer to
program a time duration for which an over
current condition must exist at the
programmed level prior to the device
tripping.
Parameter Number 125
Access Rule Get/Set
Data Type USINT
Object Mapping 2C
hex
-1-176
Group Advanced Setup
Units 0.1 Seconds
Minimum Value 0.1
Maximum Value 25.0
Default Value 1.0
L3 OC Warn Level
This parameter sets the over current warning
level for line 3.
Parameter Number 126
Access Rule Get/Set
Data Type UINT
Object Mapping 2C
hex
-1-177
2C hex -1-123
➊
Group Advanced Setup
Units 0.01 Amps
1 Amps
➊
Minimum Value 0.20
Maximum Value 5000
Default Value
LL Inhibit Time
This parameter sets the time in which line
loss protection is inhibited during a starting
sequence.
Parameter Number 127
Access Rule Get/Set
Data Type USINT
Object Mapping 2C
hex
-1-114
Group Advanced Setup
Units 0.1 Seconds
Minimum Value 0.0
Maximum Value 25.0
Default Value 0.1