RKI Instruments EAGLE 2 Manual - Manual (Page 63)

EAGLE 2 Operator’s Manual Data Logging • 53
3. If you want to clear the data logger memory, press and release the AIR ▲
YES button. The following screen appears asking you to reconfirm that
you want to clear the data logger memory.
4. If you want to clear the data logger memory, press and release the AIR ▲
YES button. The unit will display the following screen as it clears the
data.
5. The periods below “PLEASE WAIT” will disappear one at a time from
right to left as the data is cleared. When the last period disappears, the
unit is finished clearing the data and will display the following screen for
a few seconds, then return to Measuring Mode.
Data Logging
NOTE: The EAGLE 2 only logs data while in Normal Mode. If the EAGLE
2 is used in Leak Check Mode or Bar Hole Mode, no downloadable
data will be logged while it is in either of these two modes.
The EAGLE 2 features the ability to log data to its internal memory and
download it to a computer via the infrared communications port on the front
of the unit. It logs gas readings during normal operation, alarm data, and
calibration data.
To utilize the EAGLE 2’s downloading capability, you will need the Eagle 2
LOG MEMORY
ARE YOU SURE YOU
WANT TO PERMANENTLY
ERASE DATA FROM
MEMORY?
PLEASE WAIT
.......
CLEARED