RKI Instruments EAGLE 2 Manual - Manual (Page 172)

162 • Maintenance EAGLE 2 Operator’s Manual
10. Hold the PID sensor steady on the working surface with one hand and
using the other hand, locate the tabs on the electrode stack removal tool
and insert them into the slots on the side of the PID sensor near the face.
Figure 27: Using Removal Tool
11. Squeeze the removal tool to push the tabs into the sensor slots until the
electrode stack and lamp are released.
12. Carefully lift the PID sensor body away from the electrode stack and
lamp. Take care not to touch the lamp window, the flat end of the lamp,
with your fingers. If the lamp remains lodged in the sensor body,
carefully remove it with tweezers.
Figure 28: Lamp Window Location
13. If the spring in the lamp cavity comes out, place it back into the lamp
cavity.
14. Hold the lamp in one hand being careful not to touch the lamp window
with your fingers.
15. With the other hand collect a small amount of aluminum oxide powder on
a cotton swab.
Lamp Window