RKI Instruments EAGLE 2 Manual User Manual
Page 15
EAGLE 2 Operator’s Manual
About this Manual • 5
•
Chapter 3 describes the operation of the EAGLE 2.
•
Chapter 4 describes Calibration Mode which allows you to calibrate the
EAGLE 2’s active channels.
•
Chapter 5 describes the EAGLE 2’s maintenance requirements and
procedures.
•
Appendix A describes calibration of the EAGLE 2 using a sample bag.
•
Appendix B describes Setup Mode which allows you to configure
different parameters of the EAGLE 2.
•
Appendix C describes the sub PCBs that are installed for optional sensors
and how they affect gas and channel configuration.
•
Appendix D describes the PID sensors and the operation of the EAGLE 2
with a PID sensor installed.
•
Appendix E describes the ESM-01 sensors and the operation of the
EAGLE 2 with an ESM-01 sensor installed.
•
Appendix F describes the TC sensors and the operation of the EAGLE 2
with a TC sensor installed.
•
Appendix G describes the infrared CO
2
sensors and the operation of the
EAGLE 2 with an infrared CO
2
sensor installed.
•
Appendix H describes the infrared methane sensors and the operation of
the EAGLE 2 with an infrared methane sensor installed.
•
Appendix I describes the infrared hydrocarbon sensor and the operation
of the EAGLE 2 with an infrared hydrocarbon sensor installed.
•
Appendix J describes the operation of the EAGLE 2 in Methane
Elimination Mode.
•
Appendix K describes the operation of the EAGLE 2 in Bar Hole Mode.
•
Appendix L describes the operation of the EAGLE 2 in Leak Check
Mode.
•
Appendix M describes the Tank Tester Model of the EAGLE 2.
•
Appendix N describes the operation of the EAGLE 2 in Inert Mode