HYDAC CS 1000 User Manual
Cs1000 series contaminationsensor
Table of contents
Document Outline
- Trademarks
- Copyright © 2009 byHYDAC Filtertechnik GmbHall rights reserved
- Exclusion of liability
- Content
- Preface
- General safety guidelines
- New features — instruction modifications
- Storing ContaminationSensor
- Interpreting the type label
- Checking the scope of delivery
- CS1000 Features
- CS measurement modes
- Operating the CS1000 per keyboard (Only CS1x2x)
- Display — Select display after switching on the sensor
- ANA.OUT
- Display — Select displayed measurement category after switching on the sensor
- MODE – Configure measuring mode
- ANA.OUT
- Overview of menu structure
- Using switching output
- Analog Output (ANAOUT)
- HDA.SAE Signal 1/2/3/4
- HDA Status Signal 5
- HDA.ISO Signal 1/2/3/4
- HDA Status Signal 5
- HDA.ISO Signal 1/2/3/4
- HDA Status Signal 5
- HDA Signal 1/2/3/4
- HDA Status Signal 5
- Status messages
- HDA status signal 5 table
- Connecting CSI-D-5 (Condition Sensor Interface)
- CS1000 in RS-485 bus
- Taking the CS1000 out of operation
- Spare parts and accessories
- Cleanliness classes - brief overview
- Particle count (absolute) larger than a defined particle size
- Specifying a cleanliness class for each particle size
- Specify highest measured cleanliness class
- Checking/resetting factory default settings
- Technical data
- Recalibration
- Customer service
- Model code